Hi everyone.
I have many level application(Province, District, Sector, Cell and Village) and I want to make a cascading selection.
Ex: If I select Prov1, I should get Districts of that province only and sectors of that district only.
I should have used the setvalueset but it contains many cells and villages.
How to do it?
Regards,
Mussabahire.
Cascading many files in Lookup
-
- Posts: 1792
- Joined: December 5th, 2011, 11:27 pm
- Location: Washington, DC
Re: Cascading many files in Lookup
Take a look at page five of this document:
http://teleyah.com/cspro/SouthAfricaOct ... aEntry.pdf
It's titled "Dynamic Value Set from a Lookup File."
It is best to use a lookup file and then use loadcase/setvalueset to dynamically construct cascading value sets.
http://teleyah.com/cspro/SouthAfricaOct ... aEntry.pdf
It's titled "Dynamic Value Set from a Lookup File."
It is best to use a lookup file and then use loadcase/setvalueset to dynamically construct cascading value sets.
-
- Posts: 43
- Joined: September 5th, 2016, 4:55 am
Re: Cascading many files in Lookup
Than you Martin. I got it!